pumpkin head human body halloween entry door design
What if your guests into your home and be greeted by a smiling pumpkin-headed man? hmmm, can not wait to see her expression is not it? let’s make it. Suitable for almost any home design, from traditional, modern, contemporary or transitional.
Ingredients:
1. armature wire
2. Stapler and staples
3. Pole wood 30 inches in height
4. Quilt batting and polyester fiber
5. Old clothes: a turtleneck, flannel shirt, jeans, shoes, gloves and a belt
6. A pair of long underwear (pants only)
7. Pumpkin with a face artificial or natural pumpkin with a carved face
8. The batteries to light the pumpkin
Instructions how to make human pumpkin:
1. For the upper body of the pennant, to form a “skeleton” with wire armature for the arms and hands, use the wooden post as the base of the body.
2. Cut a length of 96 inches of wire frame. Staple the middle of the frame for the arms up the wooden pole.
3. quilt batting wrap the body and arms after thread, leaving 12 cm of wire exposed for each hand for security on both ends of each wire to create the center finger. Cover the body and arms with a turtleneck shirt.
4. Four fingers cut wire 10 inches long each hand and rotate your fingers over the finger center of each hand on both fingers thread. Cover your hands with gloves.
5. leg controls long underwear pieces rolled quilt batting. Sew or tie the ends of the legs closed. Put in jeans pants, long underwear.
6. Set the body on a hay bale or a chair. Place a pair of shoes under the pants legs, folding legs long underwear in the upper shoes.
7. Set the pumpkin head on top of the body, it rests on the wooden pole. Turn on the light.
