modern garden bird feeder picture
Want a modern garden bird feeder like the image above? Here are the step by step how to make it. But if you want to have it with no difficulty, visit here for vithouse.com/modern-minimalist-garden-bird-feeder-design-amy-adams-branchhome
First thing you should prepare, materials:
1-1/4 “galvanized finishing nails
1-3/4 “galvanized finishing nails
Assorted Cuts of 1 / 2 birch plywood “
sets of plexiglass 1 / 8 “clear or colored
Small Drawer Organizer (3 “x 3″ or other plastic containers)
clear acrylic rod 3 / 8 “diameter
wood glue
transparent silicone
water sealer or latex exterior paint (optional)
1 piece of duct 3 / 4 “galvanized 8 ‘length
Tools needed:
200 grit sandpaper
puzzle
knife
rule
3 / 8 drill “
clips
Drilling
hammer
Directions:
1. Glue and fasten pieces of 1 / 2 “cons-plated to form two pieces of 1 inch thick (about a room. 6″ x 9 “and another approx. 5″ x 11 “).
2. Cut a square hole near the end of the over 1 “base for inserting and maintaining your container (swimming pool).
3. Cut approximately 11 pieces of acrylic rod. 1 1 / 2 inches long each.
4. “Post closing wedge Drill holes with 3 / 8″ bit about. 3 / 8 inch deep.
5. Cut into strips about plexiglass. 5 / 8 “wide to fit between the posts and acrylic glue in place with a small piece of silicon.
6. Box in the main floor. Glue two pieces of clear plexiglass to 90 degrees and the box in the rest of the floor by using pieces of 1 / 2 “plywood cons. Leave about ΒΌ inch space at the bottom of the front wall of Plexiglas in order to release the seeds.
7. Cut a slit in the top of the roof directly on the box in support of animal feed and create a cover (penthouse) that slots into the hole. This allows the filling of access.
8. Insert another piece of Plexiglas on the inside of the feeding chamber, so that angles forward and promotes seed to exit the front of the manger.
9. Nail 1 “roof to an offset of 90 degrees at the base. This will be the excess for bird perches.
10. Drill three evenly spaced holes in the side of the base, directly opposite the feed chamber. Put three pieces of acrylic rod in the holes for the perches.
11. Install the upper balcony like the one on the base.
12. Seal the cons-plated with a paint sealant or water to protect against the elements.
13. Insert water tank and fill the room with seeds. [via hgtv]
Bird Feeder Cleaning Tips for Regularly clean: All feeders should be cleaned at least once a month, but popular feeders may need to be cleaned more often depending on the number of birds using them and the quantity of seed is consumed. Hummingbird feeders should be cleaned each time the nectar is completed.
